Casio fx-CG50 AU Bedienungsanleitung Seite 583

1. E-CON4 Mode Overview
The first time you enter the E-CON4 mode, a screen will appear for selecting a Data Logger.
Press 1(CLAB) or 2(EA-200) to select the Data Logger you want to use.
Selecting a Data Logger will cause the sampling screen (Time-based Sampling screen) to
appear.
Use the sampling screen to start sampling with the Data Logger and to view a graph of
samples.
There are four sampling modes (sampling screens), described below.
1. Time-based Sampling ... Draws a graph simultaneously as sampling is performed. Note,
2. Fast Sampling ... Select to sample high-speed phenomena (sound, etc.)
3. Period Sampling ... Select to perform periodic sampling starting from a start trigger event
4. Manual Sampling ... Sampling is performed when the [EXE] key is pressed. Up to 100
5. Mic & Speaker Mode ... Select to sample sound using the built-in microphone. You can
• The Data Logger selection screen will not appear from the next time you enter the E-CON4
mode. Instead, the Time-based Sampling screen for the selected a Data Logger will appear
first.
• To change the Data Logger, change the setting on the E-CON4 setup screen.
• Connecting a Data Logger that is different from the one specified for the calculator will
cause an error message to appear. If this happens, use the setup screen to change the
"Data Logger" setting.
ε
-1
E-CON4 Mode Overview
CLAB
however, that the graph is drawn after sampling is finished when
CH1, 2, or 3, SONIC, or [START] key is specified as the trigger
source, or when the sampling interval is less than 0.2 seconds.
and ending with an end trigger event.
samples can be taken by manual operation. Sampled data is stored in
the Statistics mode list. (CLAB only)
also output a waveform using the built-in speaker. (EA-200 only)
Data Logger Selection Screen
EA-200