Casio fx-CG50 AU Bedienungsanleitung Seite 595

5. Press c to move the highlighting to "Samples".
• When the sampling mode is "Periodic Sampling" and a CMA or Vernier Photogate
Pulley is assigned to the channel, "Distance" will be displayed in place of "Samples". For
information about "Distance", see "To configure the Distance setting" below.
6. Press e.
• This displays a dialog box for specifying the number of samples.
7. Input the number of samples and then press w.
8. Press c to move the highlighting to "Warm-up".
9. Press one of the functions keys below.
1(Auto) ... Automatically configures warm-up time settings for each sensor.
2(Manual) ... Select for manual input of the warm-up time in seconds units.
3(None) ... Disables warm-up time.
Pressing 2(Manual) displays a dialog box for specifying the warm-up time. Input the
•
warm-up time and then press w.
• When the sampling mode is "Fast Sampling", "FFT Graph" will be displayed in place
of "Warm-up". For information about "FFT Graph", see "To configure the FFT Graph
setting" below.
10. After all of settings are the way you want, press J.
• This returns to the sampling screen.
u
To configure the Distance setting
Move the highlighting to "Distance" and then press 1(NUMBER). This displays a dialog box
for specifying the drop distance for the smart pulley weight.
Input a value from 0.1 to 4.0 to specify the distance in meters.
u
To configure FFT Graph setting
In place of step 9 of the procedure under "Using Method 1 to Configure Settings", specify
whether or not you want to draw a frequency characteristics graph (FFT Graph).
1(On) ... Draws an FFT graph after sampling is finished. Use the dialog box that
appears to select a frequency.
2(Off) ... FFT Graph no drawn after sampling is finished.
ε
-13
Configuring the Sampling Setup