Connecting Rotoforce-4; Electrical Connection; Connection To Compressed Air; Connection To The Preparation Equipment - struers RotoForce-4 Gebrauchsanweisung

Connecting RotoForce-4

Electrical Connection

Connection to Compressed Air

Connection to
the Preparation Equipment
RotoForce-4
Instruction Manual
RotoForce-4 is supplied with electric cable, air hose and
connection cable.
Mount a plug on the cable or connect directly to mains:
Black and brown: phase
Yellow/green: earth
Check that the mains voltage corresponds to the voltage stated on the type
plate on the back of the machine.
Check that the specimen holder rotates anti-clockwise when
RotoForce-4 is pre-set to run in co-rotation
phases.
Mount an air hose on the enclosed quick coupling and secure
with the enclosed hose clamp.
Connect the quick coupling to the factory-mounted air hose of
RotoForce-4.
The air pressure must be between 5 bar (73 psi) and 6.5 bar (95 psi)
The air must not contain water, oil or particles. If necessary, a pressure
regulator/filter unit must be installed between air supply and RotoForce.
RotoPol alone: Connect the communication cable to the back of
RotoPol (see the Instruction Manual of RotoPol).
RotoPol with Multidoser and/or RotoCom: Connect the
communication cable to the back of Multidoser (see the
Instruction Manual of Multidoser).
IMPORTANT
r
. If not, switch two
IMPORTANT
5