Before Use; Removing/Charging/Inserting The Battery Pack; Checking The Battery Charge Level; Use - Parkside PHSSA 12 A1 Originalbetriebsanleitung

Before use

Removing/charging/inserting the
battery pack
NOTE
► The battery is supplied partially charged.
Before first use, charge the battery in the
charger for at least 1 hour. This guarantees
full battery performance. You can charge the
lithium-ion battery at any time without
shortening its service life. Interrupting the
charging process does not damage the
battery.
CAUTION!
► Always unplug the appliance before you
remove the battery pack
the battery pack to the charger.
1.) To remove the battery pack
lease button and pull the battery pack
out of the appliance.
2.) Insert the battery pack
charger .
3.) Insert the power plug into the socket. The control
LED lights up green.
4.) As long as the battery pack
red charge status indicator LED
5.) The green charge status indicator LED
you when the charging process is complete and
the battery pack
6.) Push the battery pack
ance.

Checking the battery charge level

If the appliance is switched on, the remaining
charge will be shown on the battery LED
follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
PHSSA 12 A1
from or connect
, press the re-
into the battery
is charged, the
lights up.
shows
is ready for operation.
back into the appli-
as

Use

Switching on and off
Switching on:
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in.
The LED working light
ON/OFF switch
This allows for illumination of the work area in
low lighting.
Switching off:
♦ Release the ON/OFF switch
appliance.

Setting the speed/tightening torque

♦ Press the ON/OFF switch
speed/tightening torque. Increasing the pressure
increases the speed/tightening torque.
■ The tightening torque depends on the selected
speed and impact duration.
CAUTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!
NOTE
► The integrated motor brake ensures rapid
stoppage.

Changing the direction of rotation

♦ Change the direction of rotation by pressing
the rotation direction switch
or right.

Fitting the socket

♦ Fit one of the supplied sockets
holder .
lights up when the
is depressed lightly or fully.
to switch off the
lightly for a low
towards the left
onto the tool
GB │ IE │ NI │
7 ■