Using The Vehicle Connector Plug; Replacing The Fuse; Maintenance And Cleaning - Parkside PHSSA 12 A1 Originalbetriebsanleitung

Using the vehicle connector plug

Use the supplied vehicle connector plug
ate the appliance.
♦ To do this, plug the vehicle connector plug
into the 12 V cigarette lighter of your vehicle.
As a rule, this can be found on the dashboard
of your vehicle. Many vehicles have a second
connection by the rear seats or in the boot.
■ The red LED indicates the operating display of
the vehicle connector plug
the vehicle type it is possible that the ignition
has to be switched on first.
■ Insert the battery adapter
connector plug into the appliance.
■ When you have finished your work, pull the
vehicle connector plug
connection of your vehicle.
NOTE
► Never connect your appliance without using
your appliance. The device also consumes
power in standby mode and therefore must
be disconnected from the on-board power
supply after use! Otherwise the battery will
discharge when the engine is not running.

Replacing the fuse

There is a fuse in the vehicle connector plug
protect your vehicle's wiring system. If the device
no longer works, check the fuse and replace if
necessary.
♦ Open the vehicle connector plug
fully unscrewing the screw insert anticlockwise
(using pliers if necessary) and removing it.
♦ Remove the plug tip from the fuse and take out
the fuse.
♦ Insert new 15 A fuse in your car charger
adapter.
♦ Fit the plug tip to the slightly protruding end
of the fuse and screw the previously removed
screw insert back in.
│ GB │ IE │ NI
■ 8
to oper-
. Depending on
of the vehicle
out of the 12 V
to
by care-

Maintenance and cleaning

WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
The appliance is maintenance-free.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Never allow liquids to get into the appliance.
■ Use a soft, dry cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.
■ If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
environment is cool and dry.
NOTE
► Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.
PHSSA 12 A1