Technical Data - Parkside PHSSA 12 A1 Originalbetriebsanleitung

Technical data

Hybrid cordless impact wrench: PHSSA 12 A1
Rated voltage:
Idle speed:
Max. torque clockwise
rotation:
Max. torque anticlockwise
rotation:
Suitable for metal
screws:
Tool holder:
Vehicle connector plug:
Fuse:
Use only the following battery to operate
the cordless tool: PHSSA 12 A1-1
Type:
Rated voltage:
Capacity:
Cells:
Use only the following high-speed battery
charger to charge the cordless tool:
PHSSA 12 A1-2
INPUT:
Rated voltage:
Rated power
consumption:
Fuse (internal):
OUTPUT:
Rated voltage:
Rated current:
Charging time:
Protection class:
Noise emission value:
Noise measurement value determined in accord-
ance with EN 60745. The A-rated noise level of
the power tool is typically as follows:
Sound pressure level:
Uncertainty K:
Sound power level:
Uncertainty K:
PHSSA 12 A1
12 V (DC)
0–4500 rpm
100 Nm
300 Nm
≥ M10
≤ M14
1/2"
15 A
LITHIUM ION
12 V (DC)
2 Ah
3
230–240 V ~ , 50 Hz
(alternating current)
38 W
T2A
2 A
12.6 V (DC)
2.4 A
approx. 60 min
II / (double insulation)
L = 93.7 dB (A)
PA
K = 3 dB
PA
L = 104.7 dB (A)
WA
K = 3 dB
WA
Vibration emission value:
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 60745:
Tightening screws and nuts of maximum permissible
size:
a = 8.27 m/s 2
h
Uncertainty K = 1.5 m/s
Wear hearing protection!
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons. The
specified vibration emission value can also
be used to make an initial exposure estimate.
WARNING!
► The vibration level varies depending on the
use of the power tool and may be higher
than the value specified in these instructions
in some cases. Regular use of the power tool
in this way may cause the user to underesti-
mate the vibration. Try to keep the vibration
loads as low as possible. Measures to reduce
the vibration load are, e.g. wearing gloves
and limiting the working time. Wherein all
states of operation must be included (e.g. times
when the power tool is switched off and times
where the power tool is switched on but
running without load).
2
GB │ IE │ NI │
3 ■