Before Use; Removing/Charging/Inserting The Battery Pack; Adjusting The Blade Guard; Setting Up - Parkside PMSA 12 B2 Originalbetriebsanleitung

Before use

Removing/charging/inserting the
battery pack
CAUTION!
► Always unplug the appliance before you
remove the battery pack
to the charger .
NOTE
► The battery is supplied partially charged .
Before first use, charge the battery in the
charger for at least 1 hour . This guarantees
full battery performance . You can charge the
lithium-ion battery at any time without short-
ening its service life . Interrupting the charging
process does not damage the battery .
► If the battery overheats during operation, it
cannot be charged immediately . Allow it to
cool down first .
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C .
If a lithium-ion battery is to be stored for an
extended period, the charge level should
be checked regularly . The optimum charge
level is between 50% and 80% . The storage
climate should be cool and dry and the
ambient temperature should be between
0°C and 50°C .
1 . To remove the battery pack
button and pull the battery pack
appliance .
2 . Insert the battery pack
charger .
3 . Insert the mains plug into the socket . The control
LED lights up red .
4 . The green charge level indicator LED
cates that the charging process is complete and
the battery pack
5 . Insert the battery pack
PMSA 12 B2
from or connect it
, press the release
out of the
into the high-speed
indi-
is ready .
back into the appliance .

Adjusting the blade guard

WARNING!
► The appliance may only be operated with the
blade guard fitted .
► Before each use, check that the blade guard
is securely fastened .
♦ Loosen the setting screw
clockwise (see also fig . B on the fold-out page) .
♦ Adjust the position of the blade guard
respective material thickness .
♦ Turn the setting screw

Setting up

WARNING!
► Make sure that the clamping screw
firmly tightened before putting the appliance
into operation .

Fitting/changing the cutting disc

WARNING!
► The cutting disc
during use . Allow it to cool before changing .
► Wear protective gloves to avoid injury .
► Use only the supplied clamping flanges for
assembly .
Always remove the battery pack before changing
the cutting disc !
♦ Loosen the setting screw
guard to the uppermost position .
♦ Fix the cutting disc
holes using the smaller hex key
on the fold-out page) .
♦ Remove the clamping screw
ing flange using the larger hex key
♦ Remove the cutting disc
flange . Push the cutting disc
downwards out of the blade guard
by turning it anti-
to the
clockwise again .
is
can become very hot
. Adjust the blade
in place in one of the
(see fig . A
and the clamp-
.
from the mounting
carefully
.
GB │ IE │ NI │ CY │ 7 ■