During Operation - Reely Phönix XS RtF Bedienungsanleitung

• If batteries are used as a transmitter power supply, make sure that they have sufficient remaining capacity (battery
checker). If the batteries are empty, always replace the complete set, never individual cells only.
• Before operation, always control the settings of the trim slider on the transmitter for the various steering directions
and, if necessary, adjust them.
• Always switch on the transmitter first. Only then can the receiver system be taken into operation by connecting the
flight battery in the model. Otherwise, there may be unpredictable responses and the rotor may start unintentionally.
• Always check if the rotor is correctly and securely installed before operating the product.
• Regularly example the propeller for damage. Damaged propellers pose a danger and must no longer be taken into
operation.
• Make sure that no objects or body parts are in the range or the suction area of the rotor while it is rotating.
c) During Operation
• Do not take any risks when operating the product! Your own safety and that of your environment is solely down to
you being responsible when dealing with the model.
• Improper operation may cause serious injury and property damage! Therefore make sure to keep a sufficiently safe
distance to persons, animals or objects during operation.
• Select a suitable area to operate your model plane.
• Fly your model only if your ability to respond is unrestricted. The influence of tiredness, alcohol or medication can
cause incorrect responses.
• Do not direct your model towards spectators or towards yourself.
• Never point the aerial of the transmitter directly onto the model. This significantly impairs signal transmission to the
model.
• Never switch off the remote control (transmitter) while the model is in use. After landing, always disconnect the flight
battery first. It is only after this that the remote control may be turned off.
• In case of a defect or a malfunction, remove the problem before using the model again.
• Never expose your model or the remote control to direct sunlight or excessive heat for an extended period of time.
30