Before Operation; During Operation - Reely Rex-X Nano Wichtige Informationen

• Should questions arise that are not answered by operating manual, contact us (for contact information, see chapter
1) or another expert.
The operation and use of remote control model helicopters has to be learned! If you have never steered
such a model, start especially carefully and get used to the reactions of the model to the remote control
commands first. Do be patient!
b) Before Operation
• Switch on the transmitter and then the helicopter. This is the only way for an attunement function to take place
between transmitter and receiver, so that your model will react reliably to the control commands of your transmitter.
• Check the functional reliability of your model and of the remote control system. Watch out for any visible damage
such as defective plug connections or damaged cables. All moving parts of the model must run smoothly but should
not have any play in their bearings.
• The flight battery required for operation, which is firmly installed in the model helicopter, must be charged before
operation. Ensure that the batteries in the transmitter have a sufficient remaining capacity (transmitter indication). If
the batteries are empty, always replace the complete set, never individual cells only.
c) During Operation
• Do not take any risks when operating the product! Your own safety and that of your environment is solely down to
you being responsible when dealing with the model.
• Improper operation can cause serious damage to people and property! Therefore, make sure that there is a suffi-
cient safety distance to any persons, animals or objects during operation.
• Fly your model only if your ability to respond is unrestricted. The influence of tiredness, alcohol or medication can
cause incorrect responses.
• Motors, motor regulator and flight battery can heat during operation. For this reason, take a break of 5 to 10 minutes
before recharging the flight battery.
• Never switch off the remote control (transmitter) while the model is in use. After landing, always switch off the
helicopter before the remote control.
• Never switch off the remote control while the helicopter is still switched on.
• Never expose your model or the remote control to direct sunlight or excessive heat for an extended period of time.
25