Scheppach HP2500S Originalbetriebsanleitung Seite 31

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling
• Failure to comply with the operating manual
• Repairs carried out by third parties, unauthorised spe-
cialists
• Installing and replacing non-original spare parts
• Improper use
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE 0113 not being observed
Note:
The operating manual is part of this product. It includes
important instructions for the safe, proper and econom-
ic operation of the product, for avoiding danger, for min-
imising repair costs and downtimes and for increasing
the reliability and extending the service life of the prod-
uct. In addition to the safety instructions in this operat-
ing manual, you must also observe the regulations ap-
plicable to the operation of the product in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of ap-
plication. Keep the operating manual in a good place
and hand over all documents when passing the product
on to third parties.
2. Product description (Fig. 1-19)
1. Handle
1a. Fastening screws for handle:
• HP2500S: Allen screws AF6
• HP3000S: Hexagonal bolts AF17
1b. Washers
1c. Spring washers
2. Throttle
3. Exhaust pipe
4. Air filter cover
4a. Wing nut, outer
4b. Wing nut, inner
4c. Foam filter
4d. Paper filter
5. Petrol tank cap
5a. Fuel filter insert
6. Fuel tank
7. Engine
8. Start pull cord
9. Eccentric vibration unit
10. Base plate
11. Transport wheels
12. Chassis
13. Securing nuts
13a. Rubber buffer
14. Oil dipstick for engine oil
15. Fuel valve
15a. Drain screw
15b. Fixing screw
16. Choke lever
17. Eccentric disc
18. Oil drain hose
18a. Hose clamp
18b. Screw cap
19. Belt cover
19a. Belt cover screws
• HP2500S: Allen screws AF6
• HP3000S: Allen screws AF8
19b. V-belt
20. Rubber pad with fastening bar
21 Rubber pad screws
21a. Stop nuts
21b. Washer, small
21c. Washer, large
22. Oil drain screw for eccentric vibration unit oil
23. On/off switch
24. Spark plug
25. Lifting point
26. Shift lever
3. Scope of delivery
Item
1
12
www.scheppach.com
Quantity Designation
1x Plate compactor with engine
1x Handle
1x Chassis
GB | 31