Layout Of The Safety Instructions - Lenze 8200 motec Montageanleitung

Safety information
Residual hazards, Layout of the safety instructions
1.4

Layout of the safety instructions

All safety information given in these instructions has the same layout:
}
Pictograph
{
Dangerous electrical voltage
}
General danger
(
)
66
efesotomasyon.com - Lenze
Warnings!
The device has no overspeed protection.
l
Must be provided with external or remote overload protection.
l
Suitable for use on a circuit capable of delivering not more than 5000 rms
l
symmetrical amperes, 240 V maximum (240 V devices) or 500 V maximum
(400/500 V devices) resp.
Circuit breakers (either inverse−time or instantaneous trip types) may be used in
l
lieu of above fuses when it is shown that the let−through energy (I
let−through current (Ip) of the inverse−time current−limiting circuit breaker will be
less than that of the non−semiconductor type K5 fuses with which the drive has
been tested. An inverse−time circuit breaker may be used, sized upon the input
rating of the drive, multiplied by 300 %.
Use 60/75 °C or 75 °C copper wire only.
l
If mounted on a motor the environmental rating tests for Type 4 and Type 12 shall
l
be performed.
Pictograph (indicates the type of danger)
Signal word!
(indicates the severity of danger)
Note (describes the danger and explains how to avoid it)
Signal word
Danger!
Warning!
Caution!
Stop!
Note!
EDK82MV752 DE/EN/FR 6.0
Signal word
Meaning
Impending danger for persons
Possible, very dangerous situation for
persons
Possible, dangerous situation for
persons
Possible material damage
Useful note or tip
If you observe it, handling of the drive
system will be easier.
2
t) and peak
Possible consequences if the
safety information is disregarded
Death or most severe injuries
Death or most severe injuries
Injuries
Damage of the drive system or its
surroundings
L