Safety Instructions; General Safety And Application Notes For Lenze Controllers - Lenze 8200 motec Montageanleitung

Safety instructions

Lenze controllers
1 Safety instructions
1.1

General safety and application notes for Lenze controllers

(According to: Low−Voltage Directive 73/23/EEC)
General8
Depending on their degree of protection, some parts of Lenze controllers (frequency inverters, servo
inverters, DC controllers) and their accessory components can be live, moving and rotating during
operation. Surfaces can be hot.
Non−authorised removal of the required cover, inappropriate use, incorrect installation or operation,
creates the risk of severe injury to persons or damage to material assets.
For more information please see the documentation.
All operations concerning transport, installation, and commissioning as well as maintenance must be
carried out by qualified, skilled personnel (IEC 364 and CENELEC HD 384 or DIN VDE 0100 and IEC
report 664 or DIN VDE 0110 and national regulations for the prevention of accidents must be observed).
According to this basic safety information, qualified, skilled personnel are persons who are familiar with
the assembly, installation, commissioning, and operation of the product and who have the qualifications
necessary for their occupation.
Application as directed
Drive controllers are components which are designed for installation in electrical systems or machinery.
They are not to be used as domestic appliances, but only for industrial purposes according to
EN 61000−3−2.
When installing drive controllers into machines, commissioning of these controllers (i.e. the starting of
operation as directed) is prohibited until it is proven that the machine corresponds to the regulations of
the EC Directive 98/37/EC (Machinery Directive); EN 60204 must be observed.
Commissioning (i.e. starting of operation as directed) is only allowed when there is compliance with the
EMC Directive (89/336/EEC).
The controllers meet the requirements of the Low−Voltage Directive 73/23/EEC. The harmonised
standard EN 61800−5−1 applies to the controllers.
The technical data as well as the connection conditions can be obtained from the nameplate and the
documentation. They must be strictly observed.
Warning: The controllers are products which can be installed in drive systems of category C2 according
to EN 61800−3. These products can cause radio interference in residential areas. In this case, special
measures can be necessary.
Transport, storage
Please observe the notes on transport, storage and appropriate handling.
Observe the climatic conditions according to the technical data.
Installation
The controllers must be installed and cooled according to the instructions given in the corresponding
documentation.
Ensure proper handling and avoid mechanical stress. Do not bend any components and do not change
any insulation distances during transport or handling. Do not touch any electronic components and
contacts.
Controllers contain electrostatically sensitive components, which can easily be damaged by
inappropriate handling. Do not damage or destroy any electrical components since this might endanger
your health!
60
efesotomasyon.com - Lenze
EDK82MV752 DE/EN/FR 6.0
L