Cleaning, Maintenance And Storage; Cleaning; Maintenance - Parkside Pgkga 40-Li B2 Originalbetriebsanleitung

Cleaning,

maintenance and
storage
WARNING! Risk of injury due to
unintentional start-up. Protect your-
self when performing maintenance or
cleaning work. Switch off the device
and remove the battery (25).
You should have any repair and main-
tenance work that is not described in
these instructions carried out by our
Service Centre. Only use original re-
placement parts.
Cleaning
WARNING! Electric shock! Never
spray down the device with water.
NOTICE! Risk of damage. Chemical
substances may attack the plastic
parts of the machine. Do not use any
cleaning agents or solvents.
• Keep the ventilation slits, motor
housing and handles of the ma-
chine clean. Use a damp cloth or
brush to do this.
Machine part
Screws,
nuts, bolts
Complete
machine
Blade bar
Blade bar
Saw chain
Action
Check and tighten
Visual inspection,
clean as needed
Servicing the
blade bar, p. 31
Turning the blade
bar, p. 31
Check saw chain, oil, reg-
rind or replace if necessary

Maintenance

Cleaning and maintaining the
safety cutter bar
Tools and aids required (not in-
cluded)
• Cloth
• Care oil spray
Care after each use
• Remove any green cuttings that
are stuck.
• Clean the safety cutter bar (11)
with an oily cloth.
• Maintain the safety cutter bar (11)
with a care oil spray.
• Do not cut with a blunt saw chain,
otherwise you will overload the
motor and gears of your device.
• Check the covers and protective
devices for damage and correct fit.
Replace these if necessary.
Service intervals
Carefully perform the maintenance
tasks listed in the following table on
a regular basis. Regular servicing of
your device will extend its life. Ad-
ditionally, you will achieve optimum
cutting performance and prevent ac-
cidents.
Before After 10
each use
✓
✓
✓
GB CY
After
hours each use
of use
✓
✓
29