Fitting The Auxiliary Handle; Attaching And Removing The Saw Chain - Parkside Pgkga 40-Li B2 Originalbetriebsanleitung

GB CY
5. Turn the front tubular shaft (2) with
a gentle rotating movement un-
til the lock clicks into place in the
hole on the front tubular shaft (8).
6. Screw on the wing nut (3).

Fitting the auxiliary handle

Notes
• Choose a position for the auxiliary
handle (5) within the flattened ad-
justment range marked on the bot-
tom of the tubular shaft (4).
The area is marked with two rings.
• The auxiliary handle (5) must be
attached at a sufficient distance
(≥25 cm) from the handle (29).
• The leg protection must always be
located on the operator side!
Procedure (Fig. B)
1. Loosen the grip screw (33).
2. Fold away the leg protection (7).
3. Place the auxiliary handle (5) on
the tubular shaft (4).
4. Close the leg protection (7).
5. Attach the leg protection (7) with
the grip screw (33).
Attaching and removing the
saw chain
Assembling the saw chain (Fig. C)
WARNING! Use protective gloves
CAUTION! Pay attention to the
correct rotation direction of the saw
chain (1). This is specified under the
sprocket cover (35).
1. Switch off the device and remove
the battery. Make sure that all
moving parts have come to a com-
plete stop
2. Place the device on a level sur-
face.
3. Loosen the nut (34) on the
sprocket cover (35).
4. Remove the sprocket cover (35).
20
5. Spread out the saw chain (1) in a
loop so that the cutting edges are
aligned in a clockwise direction.
6. Place the saw chain (1) in the
blade bar groove.
7. Place the saw chain (1) in the
chain sprocket (38).
8. Place the blade bar (36) and saw
chain on the coach screw (37).
NOTICE! When the lug to the right
of the coach screw sits in the slot-
ted recess on the blade bar, the
blade bar is placed correctly. It is
normal for the saw chain to sag.
9. Insert the pin of the chain ten-
sioner screw (40) into the holder
on the blade bar.
10. Fit the sprocket cover (35).
11. Tighten the nut (34) on the
sprocket cover (35) only lightly.
12. Tensioning the saw chain, p. 21
13. Tighten the nut (34) on the
sprocket cover (35) firmly.
Removing the saw chain (Fig. C)
1. Switch off the device and remove
the battery. Make sure that all
moving parts have come to a com-
plete stop
2. Place the device on a level sur-
face.
3. Loosen the tension of the saw
chain (1) (Tensioning the saw
chain, p. 21).
4. Loosen the nut (34) on the
sprocket cover (35).
5. Remove the sprocket cover (35).
6. Remove the blade bar (36) and
saw chain (1).
Hold the blade bar (36) at an angle
of approx. 45 degrees and swivel
it upwards to make it easier to re-
move the saw chain (1) from the
chain sprocket (38).