Maintenance; Maintenance Schedule; To Clean The Product; Troubleshooting - Husqvarna Collection System Bedienungsanweisung

Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.

Maintenance schedule

* = The instructions are not given in this operator's
manual.

Maintenance

Do a check of and clean the collection
bags.
Make sure that the nuts and screws are
tightened.
Make sure that the collector chute is tight-
ened.
Clean the product.

To clean the product

• Use a brush to remove unwanted material and
grass on the product.

Troubleshooting schedule

If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem
Loss of air flow.
Unusual vibrations or noise.
The collector cover is hard to close.
2651 - 002 - 04.04.2025
Maintenance
Before you do any
Daily mainte-
Before use

Troubleshooting

Cause
The collector chute or the collector cover inlet are clogged.
The container is full.
The fabric in the collector is clogged.
A solid object is in the collector.
Loose or missing screws or nuts.
Objects in the collector cause a blockage of the collector cover.
The collector cover hinge screws are too tight.
X = The instructions are given in this operator's
manual.
O = Refer to the engine manual for instructions.
Maintenance schedule for the operator
Maintenance interval in hours
nance
5
X X
X
X
• If it is necessary, use a high-pressure washer
and a weak cleaning agent. Do not exceed 1000
psi (68.9 Bar) water pressure.
25 50
X
11