Husqvarna Collection System Bedienungsanweisung Seite 9

2. Push the 2 x 5/16-18 x 1 screws from the inner
side of the cutting deck, through the cutting deck
and the discharge chute.
3. Install the 2 knobs.
To install the collector chute
1. Open the collector hood.
2. Install the collector tube in the adapter on the
collector hood.
2651 - 002 - 04.04.2025
3. Cut off the discharge chute adjacent to the 2
connectors on top of the discharge chute.
4. Install the chute adapter on the discharge chute.
5. Set the cutting deck to the lowest position.
6. Put the collector tube adjacent to the chute
adapter and cut it to the correct length.
3"
The length will be different for different mower
models. Make sure to have 3 additional inches
of the chute length that will be installed onto the
adapter.
9