Operation - Husqvarna Collection System Bedienungsanweisung

7. Install the collector tube on the chute adapter.
3"
8. Make sure that all parts are correctly attached.
To adjust the parking brake
Adjust the parking brake before you use the
collection system.
Introduction
WARNING:
product, you must read and understand
the safety chapter.
To operate the product
• Obey the operation instructions in the Operator´s
manual for the mower.
• Operate the engine at full speed when you use
the collection system.
• Move the product forward at low speed to get a
good cutting result and good collection result.
• Cut the grass 2 times if grass is high and thick.
The first cut must be at the highest cutting height
and the second time at the correct height.
10

Operation

Before you operate the
1. Put the mower in a level position.
2. Apply the parking brake.
3. Hold the brake cable (A) in position with pliers.
4. Loosen the locknut (B).
5. Turn the adjustment screw (C) until you have the
distance 3.18 cm / 1.25 in.
6. Tighten the locknut.
7. Do the same adjustment on the opposite side.
• Use the left side of the mower to cut near
objects.
• Do not cut a wet lawn. Wet grass is more
possible to become clogged in the collection
system.
• Empty the collection bags if the collection system
does not collect the cut grass. Make sure that the
collector chute is not clogged if the problem stays
when the collection bags are empty.
• Stop the mower and make sure that the
collection system is not damaged if you hit a
loose object.
• Prevent the collector chute from being twisted.
• Do not drag the collector chute along the sides of
buildings or other hard surfaces.
A
C
3.18 cm
(1.25 in)
B
2651 - 002 - 04.04.2025