Brita Top Compact Original Bedienungsanleitung Seite 33

Period of inactivity
Before a period of inactivity longer than 72 hours
Before the water dispenser is inactive for a period of more than 72 hours,
proceed as follows:
1. 1.
1. Turn off the water supply.
2. 2.
2. Close the CO
3. 3.
3. Place a note on your dispenser to ensure no one uses it
while the water supply is disconnected.
WARNING:
Danger to health due to a lack of hygiene!
Do not disconnect the water dispenser from the power supply.
62 | EN
bottle valve.
2
After a longer period of inactivity
After an inactive period longer than 24 hours or a power failure, clean the tap,
housing and drip tray with antibacterial wipes and disinfectant spray, reconnect
the water supply and open the CO
2
and flush the water dispenser with:
1. 1.
1. 2 l of unchilled
still water
2 l
2. 2.
2. 2 l of chilled still
water
2 l
WARNING! Danger to health due to a lack of hygiene!
Risk of microbial growth whenever your water dispenser is disconnected
from its power supply for more than 120 minutes. If disconnected for longer
(but less than 24 hours), restart your dispenser and flush it as explained below
(for 4 days' to 4 weeks' inactivity). If the dispenser is disconnected for more
than 24 hours, system sanitization and filter replacement are necessary.
Please contact customer service (see rear page).
Caution! After an inactive period from 4 days up to 4 weeks, flush
the water dispenser with 10 l of unchilled still water, 10 l of chilled
still water and 20 l of sparkling water.
After an inactive period of more than four weeks, system sanitization and filter
replacement are necessary. Please contact customer service (see rear page).
bottle valve. Place a vessel on the drip tray
3. 3.
3. 8 l of sparkling
water
8 l
EN | 63