Brita Top Compact Original Bedienungsanleitung Seite 28

Top Compact
1
2
3
4
5
6
7
8
9
Using the device
Dispensing water
1. Set a suitable vessel under the Caution:
tap outlet (1). Do not touch the tap outlet.
2. Dispense the desired water Danger to health due to lack of
type by pressing the respective hygiene!
button.
3. Press button until the desired
amount of water is dispensed.
Make sure not to overfill the Available water types
vessel.
Unchilled still water:
If a dispensing Unchilled still water
quantity is pre-
set, press button Chilled still:
only once briefly. Chilled still water
2. 2.
Dispensing will
stop automati- Chilled sparkling:
cally when the Strongly carbonated
1. 1.
preset quan- chilled sparkling water
tity has been
reached.
Note: For "Still Version" the end
user can choose between manual
dispensing or automatic dispens-
ing by pressing the "bottle" button.
Automatic dispensing of the preset
amount is "ON" if the bottle sign is
lit up. (pre-set the individual dis-
pensing quantity during installation).
Note: For safety reasons, the water
flow will stop automatically after
60 seconds of dispensing. Release
button and press again to continue
dispensing.
52 | EN
Please observe the foldout page!
Install / Remove rear panel and activating setting menu
To remove the rear panel at the back side of the device,
use the rear panel handle (3) and pull the panel away from
the device. The panel comes loose from the engagement.
Lay panel aside.
To reinstall the rear panel, adjust the panel into the latches
on the right hand side of the device.
Press panel into the remaining latches on the top and left
side of the device. The panel snaps into the engagement.
To activate the setting menu, press and hold setting button
for 5 seconds. Touch pad buttons blink white. Setting
menu is activated.
Note: If you push the button once again after activating the
menu, the buttons will blink red. Push the setting button
once more to return to setting menu.
EN | 53