Modem Problems - MAXDATA Vision 350M Handbuch

USER`S MANUAL

Modem Problems

The built-in modem does not respond -
n Make sure the modem driver is loaded properly.
n Go to [Start > Settings > Control Panel > System] and in the
n Make sure the phone line the notebook connected to is valid.
The fax/modem disconnects during transmission -
n Be sure to disable the Call Waiting.
n Excessive line noise might cause the connection to be
n Make sure the correct setting of the communications
The fax/modem doesn't transmit properly -
n Make sure the RJ-11 cable (the one that goes from the
n Check the serial port settings. Make sure the hardware and
n Check the communications parameters (baud rate, parity,
n The connecting system, such as the central side equipment,
n Be sure the line has a dial tone.
5-12
Go to [Start > Settings > Control Panel > Modem] and make
sure HAMR 5600 Voice Modem is listed in the Modems
Property page. Otherwise, click the Add button to add the
modem drive, which is located in the factory CD-ROM (or
floppy diskette).
Device Manager page check for possible resource or driver
conflict. See Windows on-line help or manual for how to
handle such problems.
dropped and maybe you had connected to a noisy line. To
check this, put the regular phone handset on the line and
placing a phone call. If you do hear an amount of abnormal
noise, try to make the modem connection with a different line
or contact your local telephony service company.
software. Check with the manaul of the programs to cus-
tomize the modem.
modem to the telephone line) is firmly connected to the
modem's RJ-11 jack and the telephone line socket.
software are referring to the same COM port.
data length and stop bits) specified in the communications
program.
might be busy or offline. Try to make another transmission
test to other sytem.