MAXDATA Vision 350M Handbuch Seite 369

MANUEL DE L'UTILISATEUR
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Modifications
The FCC requires the user to be notified that any changes or modifi-
cations made to this device that are not expressly approved by the
Manufacture may void the user's authority to operate the equipment.
Connections to Peripheral Devices
Connections to this device must be made with shielded cables with
metallic RFI/EMI connector hoods to maintain compliance with FCC
Rules and Regulations.
Declaration of Conformity
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
For questions regarding this declaration, contact:
on of the adresses on the back of this manual.
Use the serial number found on the product for identification.
Avis européen
Les produits avec la Marque CE sont en conformité avec la Directive
EMC (89/336/EEC) et la Directive Basse Tension (73/23/EEC)
émises par la Commission Européenne.
La conformité avec ces directives implique la conformité avec les
normes européennes suivantes :
C-2
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the
receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio or television
technician for help.
EN55022 (CISPR 22) Interférence sur les fréquences radio