The Menu Of Advanced Cmo Setup - MAXDATA Vision 350M Handbuch

The Menu of Advanced CMOS Setup
Advanced CMOS Setup for configuring system options.
Item Selections /
Sub-menu
Disabled
1st Boot
IDE-0
Device
Floppy
CDROM
2nd Boot
Device
3rd Boot
Device
Boot Up On
NumLock
Off
Password Setup
Check
Always
CPU / DRAM 66/66MHz,
Frequency 66/100MHz,
100/100MHz,
100/133MHz,
133/133MHz,
Warning:
Your notebook can't not be booted if the CPU does not support the working
frequency set in BIOS. In this case, you need to reconfigure by following the
instructions.
1) Power on the system and repeatedly press [Pg Up] key located along the
edge of keyboard.
2) After the boot screen, press [Delete] key to activate the BIOS utility.
3) Go to Advanced CMOS Setup > CPU Base Frequency and restore it to
default, 66/66MHz.
Section 2 BIOS SETUP & SECURITY
Description
Set the type of device for the 1st boot
drive that BIOS attempts to boot from after
BIOS POST completes.
Set the type of device for the 2nd boot
drive that BIOS attempts to boot from after
BIOS POST completes.
Set the type of device for the 3rd boot
drive that BIOS attempts to boot from after
BIOS POST completes.
Turn the numeric keys on or off as system
boots up.
[Setup]:
To enable the password check function
every time when BIOS Setup is executed.
[Always]:
To enable the password check function
every time the system boots.
Set the CPU and DRAM
frequency by the parameters as shown.
Your notebook can't be booted if CPU
does not support the frequency. (Refer
to the warning below.)
working
2-7