cecotec BOLERO DRESSCODE 9155 INVERTER Bedienungsanleitung Seite 94

ENGLISH
Spinning Make sure that the transport bolts have
fault, display been removed
shows "UE".
Make sure that the machine is positioned in
a stable position.
Garments may be too small or too
lightweight.
Appliance feet are not correctly adjusted.
Water inlet Check if the tap is open
fault, display
shows "IE".
Check that the water supply is not cut off.
Check that the pipes are not frozen.
Check that the filters are not clogged.
Water outlet Water outlet pipes may be too high
fault, display
shows "OE".
Pipes may be frozen.
Pipes may be blocked.
Drainage pump blocked.
Door fault, Drum door may not be properly closed.
display
shows "DE"
No heating, Unplug the washing machine.
display
shows "FE".
Water keeps Incidence on solenoid valve or pressure
entering switch
the drum,
the display
shows "FE"
94 BOLERO DRESSCODE 9155 INVERTER
BOLERO DRESSCODE 9155 INVERTER STEEL
Remove the transport bolts.
Place the machine in a fixed
and stable position.
Add more clothes.
Position the feet correctly.
Open the tap
Contact your water supplier.
Use hot water for thawing.
Remove filters and clean
them
Reposition the pipes correctly
within a height of 1 m
Make sure that the pipes are
not frozen.
Remove clogging and clean
the pipes.
Remove clogging and clean
the drain pump.
Make sure that no objects
block the door.
Contact the official Cecotec
Technical Support Service.
Contact the official Cecotec
Technical Support Service.