Troubleshooting - Cecotec Bolero Dresscode 9155 Inverter Bedienungsanleitung

ENGLISH
b.- Remove the inlet tube and place it in water at 50 ºC.
4. Water at 50 ºC
c.- Pour approximately 2 - 3 l of water at 50 ºC into the drum.
5. Water at 50 ºC
Cleaning of the drain pump filter (Suggestion: once a month)
1. Press the lock on the pump after draining (with the washing machine switched off), open
the water pump filter cover. (Attention: if there is hot water inside, wait for it to cool
down).
2. Remove the filter counterclockwise.
3. Wash the filter.
4. Go to the pump and insert the filter, tighten it clockwise and tighten the cap.
Caution:
- Secure the filter tightly to prevent leakage.
- Do not clean during operation.
NOTE: use extreme caution as spillage may occur. Use a container to collect the water.
Drum cleaning (Suggestion: one a month)
After use over a period of time, some dirt may remain. You can clean the inside and outside of
the drum using the Drum Cleaning programme.
Caution: do not insert laundry nor detergent/softener when using this function.

6. TROUBLESHOOTING

Non-faulty conditions
The door cannot be opened
- Programme is running.
- There is clothing between the door and the door seal.
A slight odour is produced
There may be a rubber odour from some components, the odour will disappear with use.
It is recommended to leave the door ajar after each wash until the inside of the drum is
completely dry, this will prevent odours and the formation of mould.
There is too little water when washing and rinsing
The washing machine only needs a little water during operation.
92 BOLERO DRESSCODE 9155 INVERTER
BOLERO DRESSCODE 9155 INVERTER STEEL