cecotec BOLERO DRESSCODE 9155 INVERTER Bedienungsanleitung Seite 12

- Check hose connections regularly to ensure that no water
leaks out.
- Do not use the appliance if parts are missing or defective or
if the power cord or plug is damaged.
- Do not use the appliance until you are sure that it is installed
in accordance with the instructions provided in this manual
and all water, drain, electrical and grounding connections
comply with all applicable local regulations and/or other
requirements.
- Before carrying out any maintenance or cleaning in the
device, unplug the appliance from the mains.
- As a safety measure, we advise you to unplug the appliance
and cut the water supply after every use. Maximum water
inlet pressure: 1 MPa. Minimum water-inlet pressure: 0.03
MPa.
- Never unplug the appliance with wet hands.
- For safety, be sure to connect the plug to a 3-pin socket.
Check carefully and make sure that your socket is properly
and reliably earthed.
- It must be possible to disconnect the appliance from the
power supply by unplugging it if the plug is accessible, or
by means of an all-pole switch upstream of the plug, in
accordance with national electrical safety regulations.
- The maximum current of the device is 10 A, make sure that
the power supply system (voltage, current and cable) is
applicable to the load of the device.
- Make sure that the socket outlet is capable of supporting
the Maximum Power rating of the appliance as indicated on
the rating plate.
- Water and electrical devices must be connected by a
qualified technician in accordance with the manufacturer's
instructions and local safety regulations.
12 BOLERO DRESSCODE 9155 INVERTER
BOLERO DRESSCODE 9155 INVERTER STEEL