cecotec BOLERO DRESSCODE 9155 INVERTER Bedienungsanleitung Seite 91

Door gasket
After washing, remove dirt, paper waste, etc., if there is any foreign matter, remove it.
Cleaning the detergent drawer
Clean the detergent drawer regularly. Take it out and wash it with clean water, then replace it.
Fig. 13
1. Push down
2. Remove
Cleaning the water inlet of the water hose
Fig. 14
(Suggestion: once every six months)
If debris accumulates, it will influence the water inlet speed.
1. Disconnect the water inlet hose.
2. Remove the coupling device according to the shown arrow.
3. Clean the inside of the coupling device.
4. Reinstall the hose after cleaning.
Cleaning the water inlet valve
of the washing machine (Suggestion: once / half a year).
1. Disconnect the hose from the washing machine.
2. Remove the filter net from the water valve.
3. Clean the filter mesh with a soft bristle toothbrush.
4. Reinstall the hose after cleaning.
Figure 15
1. Water inlet valve
In case of freezing
1. Cover the tap and the coupling device with a hot towel.
2. Remove the inlet hose and place it in 50 degree water.
3. Pour approximately 2 - 3 l of water at 50 degrees into the drum.
4. Connect the inlet hose, open the tap and switch on the washing machine, check if the
inlet and outlet are normal.
Figure 16
a.-
1. Beer tap
2. Connection pipe
3. Inlet tube
BOLERO DRESSCODE 9155 INVERTER
BOLERO DRESSCODE 9155 INVERTER STEEL
ENGLISH
91