cecotec BOLERO DRESSCODE 9155 INVERTER Bedienungsanleitung Seite 76

ENGLISH
pressure against the floor. This will help ensure the quietest and least
vibrating operation.
Follow these steps:
1. Install the appliance on level, solid surfaces. Preferably in a corner of the room.
2. If the floor is not level (or uneven), adjust the appliance's adjustable feet as needed to
level it. Do not place anything under the appliance's adjustable feet to help level it.
3. Do not extend the appliance's adjustable feet more than necessary. The more extended
the legs are, the more vibration the device will experience. Start with the adjustable legs
fully threaded and adjust each leg as needed.
4. Use a spirit level (not supplied) to check the top of the appliance and ensure it is level
from side to side and front to back.
5. Press down on each corner of the appliance's top to ensure it does not wobble. There
should be no yielding or movement. All adjustable feet must press equally against the
floor. This is just as important as ensuring that the appliance is level to avoid vibrations.
6. When the appliance is level and does not wobble, lock the adjustable feet in place by
tightening the locknuts against the bottom of the washing machine. Ensure you do this
without changing the foot height (hold the foot while tightening the locknut).
Procedure to adjust the adjustable feet
1. After determining which adjustable legs of the fixture need to be extended, have
someone lift the fixture slightly to take pressure off the leg to be adjusted.
2. Rotate the adjustable leg of the fixture to extend it downward as necessary to raise the
corner of the fixture the correct amount and level it.
3. When the foot height is correct, use the spanner (supplied) to tighten the locknut against
the bottom of the appliance and secure the foot in place. Fig. 3
Electric connection
- Do not use power strips or similar devices for connection.
- If the power cables are damaged, contact professionals for repair.
- After using the washing machine, unplug it and turn off the water tap.
- Connect the washing machine to a grounded outlet, following the wiring principles.
- Place the washing machine in a place where connection to the power outlet is easy.
Water inlet connection
Fig. 4
1. The water supply pressure must be between 30 kPa and 1000 kPa.
2. Do not damage the thread when connecting the inlet pipes to the valves.
3. Install a pressure reducing device if water supply pressure exceeds 1000 kPa.
- Two seals are supplied in the connectors at both ends of the pipe to prevent water
leaks.
- Open the tap and check for leaks at the connectors.
76 BOLERO DRESSCODE 9155 INVERTER
BOLERO DRESSCODE 9155 INVERTER STEEL