cecotec BOLERO DRESSCODE 9155 INVERTER Bedienungsanleitung Seite 77

- Check the pipes regularly. Replace them if necessary.
- Make sure that the pipes are not damaged or entangled with each other.
Figure 4 key
Standard faucet
A.
Long faucet
B.
C. Square faucet
Inlet hoses and taps connection
1. Check the rubber seals on both sides of the hose. Insert a rubber gasket in the threaded
fittings of each hose to prevent leakage. Fig. 5.
Fig. 5 key
1. Rubber seal
2. Water hose for washing machine water inlet
2. Connect the water supply hoses to the water taps by hand-tightening firmly and then
turning another 2/3 turn with pliers. Fig. 6.
⚠
WARNING: Do not over-tighten. It could damage the connection.
3. After connecting the inlet hose to water taps, open them to flush out foreign substances
(dirt, sand or sawdust) from the water lines. Let the water drain into a bucket and check
the water temperature. Fig. 7
4. Connect the hoses to the washing machine's water inlet by hand-tightening firmly and
then turning another 2/3 turn with pliers. Fig. 8
Figure 8 key
1. Water inlet
⚠
WARNING: Do not over-tighten hoses. Excessive tightening can damage the valves, leading
to leakage and material damage.
5. Check for leaks by opening the faucets. If leaking, recheck steps 1 through 4.
Drain hose installation
Fig. 9
- Secure the drain pipe with a bracket.
- To avoid damage or leakage on the floor, position the drain pipe correctly.
- To prevent siphoning, the drain hose height must be between 0.85 m and 1.25 m. In
addition, the end of the drain pipe should not be submerged in water.
BOLERO DRESSCODE 9155 INVERTER
BOLERO DRESSCODE 9155 INVERTER STEEL
ENGLISH
77