Installation - Cecotec Bolero Dresscode 9155 Inverter Bedienungsanleitung

3. INSTALLATION

- Ensure that the washing machine's installation location temperature is above 0°C. Do not
install outdoors.
- Place the washing machine correctly according to regulations and standards.
- Keep the washing machine base ventilated if installed on carpet.
- Keep a clean environment to prevent pest damage, as such damage is not covered under
warranty.
Transit bolts
Washing machines are delivered with transit bolts installed to prevent internal damage
during shipping.
Removing the transit bolts
Fig. 2
1. To prevent internal damage during transport, the washing machine comes with 4 bolts
installed. Before using the washing machine, remove these bolts (A).
2. Important: If the bolts are not removed, the washing machine will suffer from excessive
vibration, noise and possible malfunction.
3. Use the supplied spanner to loosen the 4 bolts (B).
4. Slightly rotate the bolt rubber and then remove the bolts. Keep the bolts and spanner for
possible future use (C).
Note: The bolts must always be reinstalled whenever the washing machine is transported.
5. Use the supplied caps to seal the bolt holes (D).
Warning: do not remove the drain hose fixing device.
Location requirements
- The washing machine's inclination must be less than 1 degree.
- The distance between any side of the washing machine and the power socket must be
less than 1.5 metres.
- Do not connect too many electrical appliances to the same socket.
- The wall, door and floor in the installation area must be clean.
- Install the washing machine on a hard, stable surface with floor drainage, rather than
on soft carpet or wooden flooring.
- Do not place dirty clothes or other items on the washing machine's top cover, as this
could affect its normal operation.
Appliance levelling
The appliance uses high spin speeds to remove water at the end of the
washing cycle. It is important that it is level and the adjustable feet press with equal
BOLERO DRESSCODE 9155 INVERTER
BOLERO DRESSCODE 9155 INVERTER STEEL
ENGLISH
75