Fitting Compressed Air Hose; Fitting Optional Air Vent To Exhaust Air Opening; Establishing The Power Supply - Abicor Binzel Xfume Commander Originalbetriebsanleitung

®
xFUME COMMANDER
Lay the current clamp over the cable
3.
assembly and ensure that the red point on
the current clamp always points in the
direction of the current flow.
The current clamp is automatically detected.
7.3

Fitting Compressed Air Hose

Mount the compressed air hose on the
1.
compressed air connection and connect to
the compressed air supply.
7.4

Fitting Optional Air Vent to Exhaust Air Opening

To route the cleaned air out of the building to the outside, a sealed air vent for one pipe or one
hose can be attached to the exhaust air opening as an option.
7.5

Establishing the Power Supply

► Note the safety instructions. ð 2.4.2 Safety Instructions for the Electrical Power Supply
(Page 48)
For mains connection and fuse protection, see:
ð 5 Technical data (Page 55)
BAL.1122.0 • V01
Electric shock due to damaged or improperly installed cable
The use of damaged or improperly installed cables may result in a potentially fatal
electric shock.
► Check all live cables and connections for proper installation and damage.
► Have any damaged, deformed, or worn parts replaced by a qualified electrician
only.
Fire hazard due to improper mains connection
A fire can be caused by an improper mains connection. Serious burns can be the result.
► Make sure that the operating voltage stated on the rating plate matches the mains
voltage.
WARNING
WARNING
7 Commissioning
EN - 59