Safety Instructions For Emergencies - Abicor Binzel Xfume Commander Originalbetriebsanleitung

Hochvakuum-rauchgas-absauggerät

Inhaltsverzeichnis

Verfügbare Sprachen

2 Safety

The extraction of substances and materials which are combustible, aggressive, chemical or contain

oil vapors as well as aluminum or magnesium dusts can lead to fire and explosion due to chemical

reactions. Serious injuries and irreparable damage to the device can be the result.

► Only ever use the device as intended.

► Ensure that all components have been properly installed on the fume extraction torch.

► Ensure that the fume extraction torch is connected to the fume extraction system prior to use.

► Use the fume extraction torch only with a fume extraction system that has been approved for

use in the respective country.

► Observe the local occupational health and safety regulations and guidelines.

► Check the extraction hoses at regular intervals, at least once a week, for damage and

contamination.

► Note that the applied vacuum depends on the geographic altitude of the operation site.

► Observe the warning signals and indicators on the fume extraction system. Warning signals and

indicators can imply a saturated filter or a problem with/damage to the fume extraction torch.

► Replace the extraction-specific wear parts at regular intervals. The replacement interval

required depends on the application conditions.

► Opening the air regulator is only intended to briefly reduce the volume flow at the suction

nozzle. Close the air regulator immediately afterwards. The air regulator must be closed to

ensure efficient capture of fumes.

► Observe the fume extraction device setting information as shown on the sticker on the extraction

hose connection on the fume extraction torch cable assembly.

► When welding under particularly oily ambient conditions, creepage distances consisting of

metal oxides from the welding fume can form locally on fume-carrying surfaces, which are

potentially electrically conductive. Therefore, clean the welding fume-carrying surfaces on the

fume extraction torch regularly.

► Note that when additional exhaust air hoses or exhaust air hoses from other manufacturers are

used, there can be a loss of pressure in the fume extraction torch. The components connected

must be suitable for the device and guarantee the required minimum volume flow. Check the

components regularly or a proper fit, leaks and blockages due to dust deposits.

► Heed the requirements of DIN EN ISO 21904 as far as the minimum volume flow is concerned.

If the extraction volume flow is too high, this can lead to welding faults. Check the extraction

volume flow on the extraction nozzle with the aid of a suitable test rig (depending on the

manufacturer).

2.4.7