Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Error message:
Err 12 to 16.
Meaning:
Internal fault.
Action:
This may be a temporary problem caused by external
conditions; check if the message has disappeared after 48
hours. If not, notify the installer.
Error message:
Err 17 to 24.
Meaning:
Not used.
Error message:
Err 25
Meaning:
No data link to the StecaGrid Remote.
Explanation:
The data link can be temporarily broken by atmospheric
disturbances and poor radio transmission conditions. If so,
wait until conditions have improved.
Action:
a) Check the batteries by trying a new set.
b) Try moving the unit to another position
(see 'Installation of the StecaGrid Remote'.).
c) Notify the installer.
Error message:
Err 26
Meaning:
Display not yet matched to a StecaGrid Control.
Action:
First carry out the procedure for 'Installation of the Ste-
caGrid Control (Control Unit)', and then the procedure for
'Installation of the StecaGrid Remote (Remote Display)'.
Error message:
Err 27
Meaning:
Internal fault.
Action:
Notify the installer.
Error message:
Err 28 to 39.
Meaning:
Not used.
Error message:
Err 40
Meaning:
Mains voltage out of tolerance range.
Explanation:
It is unusual for the mains voltage in northern Europe to
vary significantly from the normal 30 volt rating. This
error message generally indicates that there is no mains
supply voltage present.
Action:
a) Check that all the connectors between the inverters and
the StecaGrid Control are present and that connections
is made properly. The inverter number shown indicates
where a bad connection may be found. The LED on the
inverter(s) in question will be either not lit or at the most
flash rapidly.
b) This message can appear temporarily during inverter
start-up. The message will disappear again after approx.
10 seconds.
Error message:
Err 41
Meaning:
Mains frequency outside normal range.
717.545 | 08.13
ENGLISH
63
Werbung
Kapitel
Inhaltsverzeichnis
