Steca Grid 500 Installationsanleitung Seite 43

1 DIN rail
/3 StecaGrid 300/500
4 Data connector
5 AC connector
6 StecaGrid Control
7 DC input
(Solar panel)
8 Mains cable
DC input
(Solar panel)
/

Optional
150 mm
fig. 1
Installation of the inverter
(and the control unit StecaGrid Control)
1 1
Fix two DIN rails to the mounting surface as shown

in figure 1. The position of the lower DIN rail can also
be determined by first attaching two inverters to the
upper rail.
Three fixing holes can be used if only a single unit is to
be installed (see figure ).
2 2
Position the first inverter on the rails with the solar

panel connection terminals on top.
Slide the locking clip supplied with the unit (at the

bottom/middle of the unit) downwards.
717.545 | 08.13
AC output




153 mm
ENGLISH

5 3 m m
2 2 8 m m
fig. 
43