Steca Grid 500 Installationsanleitung Seite 53

Parameters
8 'Standby'
9 'Off'
Additional display messages:
10 Battery
11 RF status
NOTES:
1. When information is not collected by pressing the menu
button, new information is automatically received every 10
minutes. This is indicated when the antenna symbol extingu-
ishes briefly.
. If the button is pressed for 5 seconds, the StecaGrid Remo-
te will refresh system configuration information. The display
will step through the three system configuration displays: the
number of sunlight sensors, temperature sensors and inverters.
(Inverters that are not active or in stand-by mode due to low
levels of solar energy are not indicated.)
3. If no sunlight and/or temperature sensors are present in
the system, the relevant menu functions will be omitted.
4. When the batteries weaken, the battery symbol will start
to flash. The batteries should ideally then be replaced within
3 months. Having replaced the batteries, follow the instruc-
tions given in 'Installation of the Remote Display' to start the
remote display up again.
5. The kWh/day counter starts to count from the moment the
system is active. The daily total is added to the weekly and
monthly totals each evening. The weekly total is added to the
annual total at the end of each full week.
6. The oldest information is deleted when period ends are
reached, i.e. 7 days for a week, 30 days for a month and
5 weeks for a year. This means that the values shown are
rolling period totals.
717.545 | 08.13
Description
At least 1 inverter is in
'Stand-by' mode and no
inverters are active.
No inverters are active or
in 'Stand-by' mode.
If the battery symbol
flashes, the battery needs
to be replaced soon.
If the antenna symbol is
visible, data transfer is
functioning correctly.
ENGLISH
Display fields
53