Cebora TIG Sound AC-DC 2030/M Bedienungsanleitung Seite 13

power source, turn on the unit and restart the power source.
The cooling unit is active only in TIG modes.
After it is first switched on, the cooling unit shuts off after 30
seconds if the torch trigger is not pressed.
After welding, the unit remains on for 3 minutes before shut-
ting itself off. To reactivate it simply press the torch trigger or
start welding again.
4 REMOTE CONTROLS AND ACCESSORIES
The following remote controls may be connected to adjust
the welding current for this welding machine:
Art. 193 Foot control (used in TIG welding)
Art. 1260 BINZEL "ABITIG 200" Torch (200A – 35%) – m4
Art. 1262 BINZEL "ABITIG 200" Up/Down Torch (200A –
35%) – m4
Art. 1256 BINZEL "ABITIG
torch (450A) – m4
Art. 1258 BINZEL "ABITIG
water-cooled torch (450A) – m4
Art. 1655 Power source trolley
Art. 1281.03 Accessory for MMA welding
Art. 1341 Cooling unit
Art 1192+Art 187 (used in MMA welding)
ART. 1180 Connection to simultaneously connect the torch
and the pedal control.
ART. 193 may be used in any TIG welding mode with this
accessory.
Remote controls that include a potentiometer regulate
the welding current from the minimum to the maximum
current set via the knob AA.
Remote controls with UP/DOWN logic regulate the wel-
ding current from the minimum to the maximum.
450 W" water-cooled
450 W Up/Down"
13