Recording On An Md; Notes On Recording - Sony MDS-DRE1 Bedienungsanleitung

Recording on
an MD
This chapter explains how to record
onto an MD.
22 GB

Notes on Recording

If "Protected" and "C11" appear in the display
The MD is record-protected. Close the record-protect slot
to enable recording (see "To protect an MD against
accidental erasure" on page 24).
If "Din Unlock" and "C71" appear in the display
• The digital program source selected with the INPUT
switch is not properly connected. Connect the program
source correctly.
• The program source is not turned on. Turn on the
program source.
Track numbers are marked differently depending
on the menu settings and the type of source
being recorded
• When recording from a CD or MD with this unit's
INPUT switch set to "OPT" or "COAX", track numbers
are automatically marked the same as the original
program source. However, in the following cases, a
section of a recording containing more than one track
may be marked with only a single track number:
– If the same track is recorded repeatedly (using the
single-track repeat function).
– If two or more tracks with the same track number
(from different MDs or CDs) are recorded in
sequence.
– When recording tracks less than four seconds long.
• Even though INPUT is set to "OPT" or "COAX", this
unit may not be able to mark track numbers
automatically when recording from certain multi-disc
(and one-disc) CD players. In such cases, mark the track
numbers afterwards using the Divide Function (see
"Dividing a Track" on page 28).
• If the "L.Sync" parameter in the Setup Menu is set to
"L.Sync Off" when recording with INPUT set to
"ANLG", or recording from a satellite broadcast or DAT
with INPUT set to "OPT" or "COAX", this unit treats
the recorded section as a single track and only one track
number will be assigned to the recording.
• Set the "L.Sync" parameter in the Setup Menu to
"L.Sync On" when recording with INPUT set to
"ANLG", or recording from a satellite broadcast or DAT
with INPUT set to "OPT" or "COAX", to mark track
numbers automatically (see "Automatic track marking"
on page 24).
• When recording from a satellite broadcast or DAT with
INPUT set to "OPT" or "COAX", this unit automatically
marks a new track number whenever the sampling
frequency of the input signal changes (regardless of the
setting of the "L.Sync" parameter in the Setup Menu).