Required Cords; Making Connections - Sony MDS-DRE1 Bedienungsanleitung

Required cords

• Audio cords (not supplied) (2)
white
Left (L)
Right (R)
red
• Digital optical cable (not supplied) (1)
• Coaxial digital cable (not supplied) (1)

Making Connections

This section describes how to connect this unit to a mixer,
amplifier, and other components (like a CD player).
Be sure to turn off the power of all components before
making any connections.
p Connecting a mixer or amplifier
Connect the mixer or amplifier to the LINE (ANALOG)
IN /OUT jacks using audio cables (not supplied).
Connect the red plugs to the red (R) jacks and connect the
white plugs to the white (L) jacks. Be sure to make all
connections firmly to prevent hum and noise.
This unit
LINE
(ANALOG)
IN OUT
L
R
Signal flow
white
Left (L)
Right (R)
red
Mixer or Amplifier (etc.)
TAPE / MD
OUT IN
L
R
p Connecting digital components
(CD player, DAT deck, another MD deck, or an amplifier
with digital input jacks)
If you make connections to a CD player, MD deck, or DAT
deck (etc.) you can make digital recordings.
Connect using a digital optical cable (not supplied), or a
digital coaxial cable (not supplied).
• Using a digital optical cable
Remove the protective caps from the optical jacks,
then insert the plugs parallel to the jacks until they
click into place. Do not fold or tie digital optical cables.
This unit
DIGITAL
COAXIAL OPTICAL
IN IN
Signal flow
• Using coaxial digital cables
This unit
DIGITAL
COAXIAL OPTICAL
IN IN
Signal flow
z If "Din Unlock" and "C71" appear in the display
Check the digital optical cable or digital coaxial cable
connections. Also make sure the power of the connected
component is turned on.
z Automatic conversion of digital sampling rates
A built-in sampling rate converter automatically converts
digital signals with 32 kHz or 48 kHz sampling rates to the
MD sampling rate (44.1 kHz).
This allows you to make digital recordings from DAT (32 kHz
and 48 kHz) and satellite broadcasts (32 kHz and 48 kHz) in
addition to CD and MD program sources.
Note
If "Din Unlock", "C71" or "Cannot Copy" appears in the
display, digital recording is not possible. In such cases,
connect the program source to the LINE (ANALOG) IN jacks,
set INPUT to ANLG, and make an analog recording.
p After completing all other connections, use the
AC power cord to connect this unit to a wall
outlet.
Digital component
DIGITAL
OPTICAL
IN OUT
Digital component
DIGITAL
COAXIAL
IN OUT
5 GB