Assigning Cue Points To Pads - Sony MDS-DRE1 Bedienungsanleitung

z AMS can also be used to skip directly to cue points
1 Press EDIT/NO twice to display "Setup Menu".
2 Turn AMS to display "JOG:", then push AMS.
3 Turn AMS to display "JOG : Cue", then push AMS.
4 Press EDIT/NO to exit the Setup Menu.
Now, in addition to skipping to the beginning of each track,
turning AMS will also skip to any cue points you may have
specified.
To set AMS to skip only to the beginning of each track, select
"JOG : Track" in step 3.
Note
If you press a pad to start playback, the cue point for the
respective track cannot be recalled by pressing CUE. In such
cases, use AMS to skip to the cue point (as described above).
z Cue points can be assigned to pads
See "Assigning Cue Points to Pads" on page 13.
Adjusting the cue point
1
Press CUE to recall the cue point.
2
Hold down CUE and turn the scrub dial to adjust
the cue point.
The unit repeats a 3 second section starting from the
point playback was paused. The beginning of the 3
second section moves in sync with the motion of the
scrub dial.
z For more precise adjustment of the cue point
Turn the scrub dial without holding down CUE.
The CUE indicator goes out and the sound is played back in
sync with the motion of the scrub dial. (Sound may not be
produced immediately when turning the dial backwards.)
3
Press PLAY/PAUSE to start playback from the cue
point.
Assigning Cue Points to
Pads
This function allows you to assign up to 8 cue points to
pads. Once you assign a cue point to a pad, you can skip
to it simply by pressing the respective pad.
EDIT/NO
CUE
1
Recall the cue point you want to assign to a pad.
For details, see "Recalling the cue point" on page 12.
2
Hold down CUE and press the pad corresponding
to the track number containing the cue point.
For example : If you recalled the cue point for track 3
in step 1, hold down CUE and press pad 3 (BANK 1).
"Memorizing" appears momentarily and the indicator
above the pad lights red to indicate that the cue point
has been assigned.
Erasing a cue point from a pad
1
Hold down STOP and press the pad containing the
cue point you want to erase.
"Pad Erase?" and "–Rehearsal–" alternate in the
display, and the unit repeats a 3 second section
starting from the cue point to be erased.
If you decide not to erase the cue point
Press EDIT/NO or STOP.
2
Press ENTER/YES or press the same pad again.
"Complete!!" appears in the display, and the pad
indicator lights green.
AMS
Pads
(continued)
13 GB