SKF FlowMaster II Montageanleitung Und Einbauerklärung Seite 5

Safety *
The assembly must be installed,
maintained and repaired exclusively by
persons familiar with the instructions
This equipment generates high
pressure Extreme caution should be used
when operating this equipment as
material leaks from loose or ruptured
components can inject fluid through the
skin and into the body If any fluid appears
to penetrate the skin, seek attention from
a doctor immediately Do not treat injury
as a simple cut Tell attending doctor
exactly what type of fluid was injected
Any other use not in accordance with
instructions will result in loss of claim for
warranty or liability
• Do not misuse, over-pressurize, modify
parts, use incompatible chemicals,
fluids or use worn or damaged parts
• Always read and follow manufacturer's
recommendations regarding fluid
compatibility and use of protective
clothing and equipment
• Failure to comply may result in personal
injury and/or damage to equipment
NOTE
Refer to model 85733 manual
404554 for all other safety
considerations
Explanation of
signal words for
safety
NOTE
Emphasizes useful hints and
recommendations as well as
information to prevent property
damage for efficient and trouble-
free operation
CAUTION

Indicates a dangerous situation that
can lead to light personal injury if
precautionary measures are ignored
WARNING

Indicates a dangerous situation that
could lead to death or serious injury if
precautionary measures are ignored
DANGER

Indicates a dangerous situation that
will lead to death or serious injury if
precautionary measures are ignored
WARNING

Do not operate equipment
without reading and fully
understanding safety
warnings and instructions
Failure to follow warnings and
instructions may result in serious
injury
WARNING

Do not perform
maintenance or service
prior to disconnecting
power to pump assembly
Disconnect all hydraulic and
electric power before operating
Failure to comply may result in
death or serious personal injury
WARNING

Do not exceed maximum
rated outlet pressure
Pump is not equipped with
high pressure shut-off valve
Failure to comply may result in
death or serious personal injury
WARNING

Do not allow fluid to leak
onto floor when operating
equipment If spill occurs,
clean any fluid on floor before
continuing operation
Failure to comply may result in
death or serious personal injury
5
WARNING

Do not use this equipment to
supply, transport, or store
hazardous substances and mixtures
in accordance with annex I part 2-5
of the CLP regulation (EG
1272/2008) or HCS 29 CFR
1910 1200 marked with GHS01,
GHS06 and GHS08 hazard
pictograms shown:
CAUTION

Do not operate equipment without
wearing personal protective gear
Wear eye protection Protective
equipment such as dust mask, non-
skid safety shoes or hard hat used
for appropriate conditions will
reduce personal injuries
Failure to comply may result in
light personal injury
CAUTION

System may create a high-
pressure outlet during
operation Use extreme
caution when operating as
equipment generates very high
grease pressure
Failure to comply may result in
light to moderate personal injury
CAUTION

Do not operate equipment
prior to inspecting all fluid
connections Tighten
securely to prevent fluid leaks
Failure to comply may result in
light personal injury
* Indicates change