Welding Parameters For Tig-Welding - Fronius Rc Panel Smart/Tmc Bedienungsanleitung

Welding parame- Welding parameters for TIG welding (TIG)
ters for TIG‑wel-
ding
Welding parameters in the left-
hand display section:
Icons for 2-/4-step mode
1)
Icons for spot welding
Icons for a foot-operated remote control
38
Starting current
UpSlope + time informati-
on
Main current
Lowering current
DownSlope + time infor-
mation
Final current
Only for 4-step mode
Starting current
UpSlope + time informati-
on
Main current
DownSlope + time infor-
mation
Final current
Starting current
UpSlope + time informati-
on
Welding parameters in the right-
hand display section:
1)
2)
Only for 2-step mode
3)
Only if the torch trigger parame-
ter on the welding machine is set to
off (torch trigger off).
Gas pre-flow
Tacking (TAC)
Pulse frequency
Gas post-flow
Starting current time
Comfort stop‑sensitivity
(CSS - comfort stop sensi-
3)
tivity)
Gas pre-flow
Tacking (TAC)
Pulse frequency
Gas post-flow
Comfort stop‑sensitivity
(CSS - comfort stop sensi-
3)
tivity)
Gas pre-flow
Tacking (TAC)
2)