Welding Parameters For Mig/Mag Welding; Welding Parameters For Mig/Mag Manual Welding - Fronius Rc Panel Smart/Tmc Bedienungsanleitung

Welding parame- Welding parameters for MIG/MAG standard synergic welding and MIG/MAG
ters for pulse synergic welding (Standard, Pulse)
MIG/MAG wel-
ding
Welding parameters in the left-
hand display section:
1)
If one of the welding parameters (welding current, wire speed, and sheet thic-
kness) is changed in Synergic operation, the remaining two parameters are also
adjusted.
Welding parame- Welding parameters for MIG/MAG standard manual welding (Manual)
ters for
MIG/MAG ma-
Welding parameters in the left-
nual welding
hand display section:
Wire speed [m/min or ipm]
Welding current
Sheet thickness [mm or in-
ches]
Process line
Job Mode
For special 2-/4-step mode
Wire speed [m/min or ipm]
Englisch (US)
Welding parameters in the right-
hand display section:
Arc length correction
Dynamic correction
Pulse correction for pulse
Gas pre-flow
Gas post-flow
Starting current
Starting current time
1)
UpSlope
1)
DownSlope
Final current
Final current time
Welding parameters in the right-
hand display section:
Welding voltage
Arc-force dynamic
1)
1)
1)
1)
35