PCE Instruments PCE-DFG 50K XF Bedienungsanleitung Seite 90

5.2.3.2.2 Stop by date and time
Use the ▲/▼ keys to select Date & time and confirm the selection with the OK key to set a stop
date and time via the input dialogue.
An input dialogue will now open where you must first set the date. Use the ► key to select the
digit to be changed. The digit to be changed is highlighted in orange. With the ▲/▼ keys, you can
now select the day within the range 01 ... 31 (depending on the month), the month within the
range 01 ... 12 and the year within the range 2023 ... 2060. To confirm the set value, press the
OK key again.
A new dialogue window opens automatically. Use the ► key to select the digit to be adjusted.
The digit to be changed is highlighted in orange. The ▲/▼ keys can now be used to change the
hour within the range 00 ... 24 (depending on the time format) and the minute within the range 00
... 59. To confirm the set value, press the OK key again.
The setting is accepted and an orange tick appears next to "Date & time". You can now return to
the previous
Note:
At least the stop time must be in the future and, if applicable, be later than the start date and time.
Otherwise, the meter will give an error message.
5.2.3.2.3 Stopping the data logger when the value falls below the limit value
To change the value via the input dialogue, navigate to the item Limit value with the ▲/▼ keys
and press the OK key. Use the ► key to select the digit to be adjusted. The digit to be changed
is highlighted in orange. Use the ▲/▼ keys to change the selected digit within the range 0 ... 9.
To confirm the value set as the limit value, press the OK key again. Now the setting for the limit
value is saved and the limit value is displayed in orange. You can now return to the previous menu
by pressing the back key.
Note:
Ensure correct selection of the Measuring direction for tension and compression tests. By default,
the meter sets the limit value for the stop condition equal to the limit value of the start condition
(if set).
menu by
© PCE Instruments
15
pressing the back key.