PCE Instruments PCE-DFG 50K XF Bedienungsanleitung Seite 109

5.2.5.3 Calibration parameters
Here, all the parameters related to the calibration of the force gauge can be set. This menu is
protected against access by the code 1703. This can be entered in a pop-up dialogue. The entry
always starts at the first digit. To enter the code, use the ► key to select the digit to be adjusted.
The digit to be changed is highlighted in orange. Use the ▲ or ▼ key to change the selected digit
within the range 0 ... 9. To confirm the entered code, press the OK key again. If the code was
entered correctly, you will enter the calibration menu, otherwise an error message will appear.
5.2.5.3.1 Sensitivity (mV/V)
Here, you can set the maximum load units, the maximum load value that the force gauge can
support, the sensitivity of the gauge and the zero offset. In order to change any of these
parameters, use the ▲ and ▼ keys to move to the desired item and press OK key to select it.
© PCE Instruments
34