PCE Instruments PCE-DFG 50K XF Bedienungsanleitung Seite 81

5.2.2.2 Surface
2
It is also possible to set the surface value. The surface value can be set to a value from 0.01 cm
2
to 999.99 cm and is used for the calculation of the pressure if the display unit "kPA" or "Pa" has
been selected.
Use the ▲ or ▼ key to select the menu item Surface and press the OK key to change the value
via the input dialogue. To change the value, use the ► key to select the digit to be adjusted. The
digit to be changed is highlighted in orange. With the ▲/▼keys, the selected digit can now be
changed within the range 0 ... 9. To confirm the set value for the force area, press the OK key
again and the device will go back to the Measurement menu automatically. To abort the setting,
press the back key.
© PCE Instruments
6