PCE Instruments PCE-DFG 50K XF Bedienungsanleitung Seite 83

5 different alarm modes are available
Mode
Off
Overrun
Undercutting
Window mode
Inverse window mode
To select the mode, navigate to the Mode menu item with the ▲/▼ keys and press the OK key.
In the following submenu, you can now select the mode with the ▲/▼ keys and confirm with the
OK key. An orange tick is then displayed next to the selected setting. You can now return to the
Alarm menu with the help of the back key.
5.2.2.3.2 Set alert limits
The alarm limits can be set under the menu item Alert limits. Use the ▲ or ▼key to select the
menu item Alert limits and press the OK key to enter the submenu.
Use the ▲ or ▼key to select the menu item Upper limit or Lower limit and press the OK key to
change the value in the input dialogue. To change the value, use the ► key to select the digit to
be adjusted. The digit to be changed is highlighted in orange. With the ▲/▼keys, the selected
digit can now be changed within the range 0 ... 9. To confirm the value set for the selected limit,
press the OK key again. You can now return to the Alert menu by pressing the back key.
Description
The alarm is deactivated.
The alarm is triggered as soon as the measured variable exceeds
the upper limit value.
The alarm is triggered as soon as the measured variable falls
below the lower limit value.
The alarm is triggered as soon as the measured variable is within
the range between the upper and lower limit values.
The alarm is triggered as soon as the measured variable is outside
the range between the upper and lower limit values.
© PCE Instruments
8