Werbung
EN
Fluid Trap Cleaning
1
Lower floor tool by pressing down on toe
cap area behind hose.
4
Unclip front of fluid trap while lifting trap
from floor tool.
Daily
Keep the machine clean.
Ensure brushes / pads / squeegee / filters are in good condition.
Check for any worn or damaged parts and replace immediately.
Drain and rinse dirty water tank after every use.
Weekly – as daily and –
Check brush / pad and deck skirt, wipe and rinse.
Check floor tool blades for wear and wipe clean.
Clean separator assembly including filter and check condition of seal.
Flush out system with clean water and clean filters.
Regular Maintenance
2
Remove hose from floor tool.
5
Wash thoroughly and remove any debris.
When cleaning check rubber seal for any cracks
or damage.
49
49
3
Pull the floor tool away from the machine.
6
B
Refit by locating lug in floor tool (A) and
lowering fluid trap until front clip clicks (B).
A
Werbung
