Werbung
EN
CONTENTS
● Owner Manual
!
● Battery Charger & Lead
● Battery Pack
● Scrub Brush
● Squeegee Assembly
Main tank assembly removal
1
Remove the tank assembly from the front of
the machine. Press button at the top on front
of the tank assembly (A), lift the tank assembly
up towards the main handle and out.
Brush Fitting
Make sure battery is removed
before fitting or removing brushes.
Make sure the handle is locked in upright
position and storage wheels are retracted.
Remove the tank assembly (and battery if
fitted) gently lay machine on its front
Floor tool and vacuum hose fitting
1
Push the floor tool carrier down and push the floor tool onto the retaining clips (1 & 2).
Take the hose and fit it securely over the centre fitting on the floor tool. Follow the arrows for the correct fit, making sure that the
positioning collar is outside of the machine. Make sure hose stays loose and is not over stretched.
Quick Set-up Guide
!
PLEASE READ BEFORE COMMENCING ANY
OPERATION AFTER THE REMOVAL OF ALL THE
PACKAGING, CAREFULLY OPEN AND CHECK THE
2
Lift and tilt the top of the tank assembly away from the handle as you remove.
Place the tank assembly on a suitable surface in its upright/uppermost position.
1
Push the brush / pad holder onto the
brush motor mount (1 & 2). Note: Gloves
are recommended to be worn whilst fitting
and removing the brushes.
2
15
15
CONTENTS.
3
2
To remove the brush, place your fingers
behind the brush deck in locations shown
and gently wiggle off.
3
!
!
Make sure
positioning collar
is located outside
of machine
Werbung
