13.3 POSSIBILITÉ D'INTERFÉRENCES RADIO/TÉLÉVISION
Pays
Déclarations
• This equipment has been tested and found to comply with the limits for a Class B
États-Unis
digital device, pursuant to Part 15 of the FCC Rules.
• These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy, and if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
Canada
This device contains license-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada's license-exempt RSS(s).
Operation is subject to the following two conditions:
• This device may not cause interference.
• This device must accept any interference, including interference that may cause
undesired operation of the device.
13.4 DÉCLARATION DE CONFORMITÉ UE SIMPLIFIÉE
Inogen déclare par la présente que ce produit est conforme aux exigences essentielles et aux autres
dispositions pertinentes de la directive 2014/53/UE et à toutes les autres exigences de la directive
européenne applicable. La déclaration de conformité complète se trouve à l'adresse suivante :
www.inogen.com/Compliance
13.5 DÉCLARATION DE CONFORMITÉ BRITANNIQUE SIMPLIFIÉE
Inogen déclare par la présente que ce produit est conforme aux exigences essentielles des règlements 2017
sur les équipements radio et de toutes les autres réglementations britanniques applicables. La déclaration
de conformité complète se trouve à l'adresse suivante : www.inogen.com/Compliance
©2024 Inogen, Inc. Tous droits réservés.
º Reorient or relocate the receiving antenna.
º Increase the separation between the equipment and receiver.
º Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
º Consult the dealer or an experienced radio/TV technician for help.
Page 75 / 272
96-13613-00-01 A