Simplified Eu Declaration Of Conformity - Inogen Rove 6 Benutzerhandbuch

13.3 POTENTIAL FOR RADIO/TELEVISION INTERFERENCE
Country Statements
United States • This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.
• These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy, and if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Canada This device contains license-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada's license-exempt RSS(s).
Operation is subject to the following two conditions:
• This device may not cause interference.
• This device must accept any interference, including interference that may cause
undesired operation of the device.

13.4 SIMPLIFIED EU DECLARATION OF CONFORMITY

Inogen hereby declares that this product is in compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU and all other applicable EU directive requirements.
The complete declaration of conformity can be found at: www.Inogen.com/Compliance
13.5 SIMPLIFIED UK DECLARATION OF CONFORMITY
Inogen hereby declares that this product is in compliance with the essential requirements per
Radio Equipment Regulations 2017 and all other applicable UK regulations. The complete declaration
of conformity can be found at: www.Inogen.com/Compliance
©2024 Inogen, Inc. All rights reserved.
º Reorient or relocate the receiving antenna.
º Increase the separation between the equipment and receiver.
º Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
º Consult the dealer or an experienced radio/TV technician for help.
Page 36 of 272 96-13613-00-01 A