C) Checking The Transmitter's Power Supply - Reely Bimot Bedienungsanleitung

c) Checking the Transmitter's Power Supply

When new batteries are inserted, switch on the transmitter with the function switch (see figure 1, item 7) for test purpo-
ses. For this, push the function switch from the right switch position „OFF" to the left switch position „ON".
To indicate correct voltage supply, the red function control lamp lights up (see figure 1, item 2), and the transmitter
issues a short signal.
If the operating voltage is no longer sufficient for proper operation of the transmitter, the red function indicator lamp
starts to flash and the transmitter emits warnings sounds in a quick sequence. In this case, stop operation of your
model as quickly as possible.
Insert new batteries for further operation of the transmitter.
Attention!
The receiver electronics in the model are equipped with an integrated protective circuit which prevents the
drive motors from starting unintentionally.
Nevertheless, ensure before each operation of the transmitter that the control stick for the motor rotation
speed (see Fig. 1, item 4 or 12, depending on mode set) is in the „Motor off" position for reasons of safety.
For this purpose, the control stick must be pushed down completely or pulled towards you as far as possib-
le.
41